Easy To Build Beginner's
Foam Insulator Homemade Penis Extender:
This is a simple to build homemade penis extender.
The parts are easy to find at any hardware store. There are two
components to build: a rubber retaining ring to brace the extender
behind the glands and the foam extender itself.
Building The Retaining Ring:
To
make the retaining ring you will need these parts: a small cord
lock, a bootlace (the thick round kind used for hiking boots)
and a few inches of surgical tubing (a yellowish, very flexible
and rubbery tubing that can be found at Home Depot in the USA).
Cut a length of tubing so that when wrapped
around your penis immediately before the head it is about a half
inch short of coming together. Thread the bootlace through the
tubing. Now run both end of the lace through the cord lock and
pull until you end up with a loop at the tubing end. Tie the free
ends of the bootlace together so that they also form a loop a
few inches long.
After you have it to the size you desire you
can cut the excess bootlace ends off. What you should now have
is a figure eight look with the cord lock in the middle and one
loop with the tubing, one loop just bootlace.
Building The Extender:
You
will need a section of foam pipe insulator (buy long tubes about
¼ inch thick and an inch in inside diameter) available at hardware
stores Cut a length that when wrapped around your penis will stretch
it full length from base to the head. Make it just long enough
for a gentle stretch.
Line the extender with duct tape to strengthen
it and use Velcro to fasten around your penis. One of the Velcro
strips should be at the very end of the extender next to the head
so this area will be closed securely.
Using Your Foam Extender:
To use it simply put on the surgical tubing
circle behind the head and then stretch out your penis and slip
on the extender. Adjust for comfort and tighten the Velcro fasteners.
You will need to stop and stimulate blood
flow to the penis about every half hour or so. When you feel ready
to move to a longer extender you can cut a new one with added
length or try cutting short add on pieces and slip it between
the extender and base of your penis.
Remember to use heat before and during the
use of this homemade extender device. Also never wear any device
while you sleep. The chance of losing circulation to your penis
and causing damage is too great.
